Orthographic and Pictorial ViewsĪSME Y14.24. Metric Drawing Sheet Size and FormatĪSME Y14.2, Line Conventions and LetteringĪSME Y14.3.
Decimal Inch Drawing Sheet Size and FormatĪSME Y14.IM. The following are ASME Y14 standards that are basic engineering drawing standards:ĪSME Y14.1. Multiview drawings contained within figures are third-angle projection. Dimensions that locate or orient and are not shown are considered basic and shall be queried to determine the intended requirement When the letter h” is used in figures for letter heights or for symbol proportions, select the applicable letter height in accordance with ASME Y14.2. The absence of dimensioning and tolerancing annotations in a view may indicate that the product definition is defined in 3D. Some figures are illustrations of models in a three-dimensional environment. The absence of a paragraph reference is not a reason to assume inapplicability. To assist the user of this Standard, the designated paragraph(s) in which an Illustration is referenced appears in the lower right-hand corner of each figure.
To comply with the requirements of this Standard, actual data sets shall meet the content requirements set forth in the text. The absence of figure(s) has no bearing on the applicability of the stated requirements or practice. In other cases, figures are incomplete by intent so as to illustrate a concept or facet thereof. In some cases, figures show a level of detail as needed for emphasis. The figures in this Standard are intended only as illustrations to aid the user in understanding the practices described In the text. Customary units could equally have been used without prejudice to the principles established. The International System of Units (SI) is featured in this Standard. The acronym is used thereafter throughout the text. A statement requiring the addition of a note with the qualifier such as is a requirement to add a note, and the content of the note is allowed to vary to suit the application.Īcronyms and abbreviations are spelled out the first time used in this Standard, followed by the acronym or abbreviation in parentheses. Notes depicted in initial uppercase or lowercase letters are to be considered supporting data to the contents of this Standard and are not Intended for literal entry on drawings. Notes depicted in this Standard in ALL UPPERCASE letters are intended to reflect actual drawing entries. ASME Y14.5.1-2019 pdf free.Mathematical Definition of Dimensioning and Tolerancing Principles Engineering Product Definition and Related Documentation Practices.
0 kommentar(er)
